In mechanics and physics, simple harmonic motion is a type of periodic motion where the restoring force is directly proportional to the displacement. It can serve as a mathematical model of a variety of motions, such as the oscillation of a spring. In addition, other phenomena can be approximated by simple harmonic motion, including the motion of a simple pendulum as well as molecular vibration. Simple harmonic motion is typified by the motion of a mass on a spring when it is subject to the linear elastic restoring force given by Hooke's Law. The motion is sinusoidal in time and demonstrates a single resonant frequency. In order for simple harmonic motion to take place, the net force of the object at the end of the pendulum must be proportional to the displacement.
Simple harmonic motion provides a basis for the characterization of more complicated motions through the techniques of Fourier analysis.
Introduction
Simple harmonic motion shown both in real space and
phase space. The
orbit is periodic. (Here the velocity and position axes have been reversed from the standard convention in order to align the two diagrams)
In the diagram a simple harmonic oscillator, comprising a weight attached to one end of a spring, is shown. The other end of the spring is connected to a rigid support such as a wall. If the system is left at rest at the equilibrium position then there is no net force acting on the mass. However, if the mass is displaced from the equilibrium position, a restoring elastic force which obeys Hooke's law is exerted by the spring.
Mathematically, the restoring force F is given by

\mathbf{F}=k\mathbf{x},
where F is the restoring elastic force exerted by the spring (in SI units: N), k is the spring constant (N·m^{−1}), and x is the displacement from the equilibrium position (in m).
For any simple harmonic oscillator:

When the system is displaced from its equilibrium position, a restoring force which resembles Hooke's law tends to restore the system to equilibrium.
Once the mass is displaced from its equilibrium position, it experiences a net restoring force. As a result, it accelerates and starts going back to the equilibrium position. When the mass moves closer to the equilibrium position, the restoring force decreases. At the equilibrium position, the net restoring force vanishes. However, at x = 0, the mass has momentum because of the impulse that the restoring force has imparted. Therefore, the mass continues past the equilibrium position, compressing the spring. A net restoring force then tends to slow it down, until its velocity reaches zero, whereby it will attempt to reach equilibrium position again.
As long as the system has no energy loss, the mass will continue to oscillate. Thus, simple harmonic motion is a type of periodic motion.
Dynamics of simple harmonic motion
For onedimensional simple harmonic motion, the equation of motion, which is a secondorder linear ordinary differential equation with constant coefficients, could be obtained by means of Newton's second law and Hooke's law.

F_{net} = m\frac{\mathrm{d}^2 x}{\mathrm{d}t^2} = kx,
where m is the inertial mass of the oscillating body, x is its displacement from the equilibrium (or mean) position, and k is the spring constant.
Therefore,

\frac{\mathrm{d}^2 x}{\mathrm{d}t^2} = \left(\frac{k}{m}\right)x,
Solving the differential equation above, a solution which is a sinusoidal function is obtained.

x(t) = c_1\cos\left(\omega t\right) + c_2\sin\left(\omega t\right) = A\cos\left(\omega t  \varphi\right),
where

\omega = \sqrt{\frac{k}{m}},

A = \sqrt,
and, since T = 1/f where T is the time period,

T = 2\pi \sqrt{\frac{m}{k}}.
These equations demonstrate that the simple harmonic motion is isochronous (the period and frequency are independent of the amplitude and the initial phase of the motion).
Energy
The kinetic energy K of the system at time t is

K(t) = \frac{1}{2} mv^2(t) = \frac{1}{2}m\omega^2A^2\sin^2(\omega t  \varphi) = \frac{1}{2}kA^2 \sin^2(\omega t  \varphi),
and the potential energy is

U(t) = \frac{1}{2} k x^2(t) = \frac{1}{2} k A^2 \cos^2(\omega t  \varphi).
The total mechanical energy of the system therefore has the constant value

E = K + U = \frac{1}{2} k A^2.
Examples
The following physical systems are some examples of simple harmonic oscillator.
Mass on a spring
A mass m attached to a spring of spring constant k exhibits simple harmonic motion in closed space. The equation

T= 2 \pi{\sqrt{\frac{m}{k}}}
shows that the period of oscillation is independent of both the amplitude and gravitational acceleration. The above equation is also valid in the case when a constant force is being applied on the mass, i.e. a constant force can not change the period of oscillation.
Uniform circular motion
Simple harmonic motion can in some cases be considered to be the onedimensional projection of uniform circular motion. If an object moves with angular speed ω around a circle of radius r centered at the origin of the xy plane, then its motion along each coordinate is simple harmonic motion with amplitude r and angular frequency ω.
Mass of a simple pendulum
The motion of an undamped
pendulum approximates to simple harmonic motion if the amplitude is very small relative to the length of the rod.
In the smallangle approximation, the motion of a simple pendulum is approximated by simple harmonic motion. The period of a mass attached to a pendulum of length ℓ with gravitational acceleration g is given by

T = 2 \pi \sqrt{\frac{\ell}{g}}
This shows that the period of oscillation is independent of the amplitude and mass of the pendulum but not the acceleration due to gravity (g), therefore a pendulum of the same length on the Moon would swing more slowly due to the Moon's lower gravitational field strength.
This approximation is accurate only in small angles because of the expression for angular acceleration α being proportional to the sine of position:

m g \ell \sin(\theta)=I \alpha,
where I is the moment of inertia. When θ is small, sin θ ≈ θ and therefore the expression becomes

m g \ell \theta=I \alpha
which makes angular acceleration directly proportional to θ, satisfying the definition of simple harmonic motion.
Scotch yoke
A Scotch yoke mechanism can be used to convert between rotational motion and linear reciprocating motion. The linear motion can take various forms depending on the shape of the slot, but the basic yoke with a constant rotation speed produces a linear motion that is simple harmonic in form.
See also
Notes

^ The choice of using a cosine in this equation is arbitrary. Other valid formulations are:

x(t) = A\sin\left(\omega t +\varphi'\right),
where

\tan \varphi' = \left(\frac{c_1}{c_2}\right),
since cosθ = sin(π/2  θ).

^ The maximum displacement (that is, the amplitude), x_{max}, occurs when cos(ωt + φ)or (ωt  φ) = 1, and thus when x_{max} = A.
References
External links
This article was sourced from Creative Commons AttributionShareAlike License; additional terms may apply. World Heritage Encyclopedia content is assembled from numerous content providers, Open Access Publishing, and in compliance with The Fair Access to Science and Technology Research Act (FASTR), Wikimedia Foundation, Inc., Public Library of Science, The Encyclopedia of Life, Open Book Publishers (OBP), PubMed, U.S. National Library of Medicine, National Center for Biotechnology Information, U.S. National Library of Medicine, National Institutes of Health (NIH), U.S. Department of Health & Human Services, and USA.gov, which sources content from all federal, state, local, tribal, and territorial government publication portals (.gov, .mil, .edu). Funding for USA.gov and content contributors is made possible from the U.S. Congress, EGovernment Act of 2002.
Crowd sourced content that is contributed to World Heritage Encyclopedia is peer reviewed and edited by our editorial staff to ensure quality scholarly research articles.
By using this site, you agree to the Terms of Use and Privacy Policy. World Heritage Encyclopedia™ is a registered trademark of the World Public Library Association, a nonprofit organization.